{}
{"support":{"yesButton":"Ano","noButton":"Ne","feedback":{"title":"Co můžeme udělat pro zlepšení?"},"submitButton":"Odeslat","successMessage":"Děkujeme za váš názor","title":"Bylo to užitečné?","feedbackPercentLabel":"lidí shledalo toto užitečným","captcha":{"error":"Zaškrtněte políčko"}}}

Prohledejte časté dotazy

{"searchBar":{"inputPlaceholder":"Hledejte podle klíčového slova nebo se zeptejte","searchBtn":"Hledat","error":"Zadejte klíčové slovo pro hledání"}}

NetBotz 750/755 "400 error" if not filling in identification fields fully

Issue:
NetBotz 750/755 "400 error" if not filling in identification fields fully

Product Line:
NetBotz

Environment:
NBRK0750
NBWL0755
Version 5.2.4 firmware and below

Cause:
If any of the identification fields are left blank when configuring Settings-->Identification on a NetBotz 750 or 755, a 400 error may appear

Resolution:
Be sure to fill each field with text and the error should not appear. It has also been seen where adding text, saving, then re-editing may allow for a blank field.

This issue is resolved in the NetBotz 5.3 release.