Technical FAQs

Ask a Question

Filter results

    APC Recall for the Back-UPS CS (120v and 230v); How do I know if my unit is one of the affected units?
    The affected CS 350 and CS 500 models were manufactured between November 2000 and December 2002 and sold primarily through distributors, catalog and retail ...
    What is the expected life of my APC UPS battery?
    APC Back-UPS , smart- ups , overload, ... , Smart- Ups VT, Galaxy ... PX 250- 500 , Galaxy, ...
    Video: Why might my APC Back-UPS Product be beeping?
    UPSs are generally installed and placed in places not easily seen by a user (i.e., under a desk, in a wiring closet, etc). Therefore, in order to provide proactive warnings of changing UPS and power conditions to users, APC's UPSs have audible tones. An occasional single beep from the UPS is normal UPS operations. This means that the UPS is protecting the load. ... Please refer to your Back-UPS user manual for the complete list of which audible tones the unit you purchased has.
    Why might the Overload LED be lit on my APC Back-UPS?
    All APC Back-UPS Product Families. All APC Back-UPS Product Families. ... Each model of Back-UPS is capable of ... ... is rated for 500 Volt Amps ( ... APC's UPS Sizing Tool ... number of your UPS ) by using ... contact APC's Technical Support ... when turning the UPS on with the ... When using the UPS as a "master on/off" switch, the Overload Led will illuminate briefly when the connected equipment powers up at the same time that the UPS does. contact APC's Technical Support ... If the Overload Led is flashing CONTINUOUSLY, this may indicate an internal fault with the UPS .
    What are the basic troubleshooting steps for the APC Back-UPS Pro with Networking bg500 ?
    ... steps for the APC Back-UPS Pro with Networking ... APC Back-UPS Pro with Networking ... ... find the your APC AV J- ... ... Problem: The Back-UPS will not turn ... The Back-UPS has not been ... The Back-UPS is not connected ... ... the event the Back-UPS receives no AC ... ... button until the Back-UPS emits two beeps ... ... cold boot the UPS when no AC ... The UPS will not cold ... ... is restored the UPS can be turned ... ... Problem: The Back-UPS is on, ... A Back-UPS overload condition has ...
    Why might the LEDs on my Back-UPS or Smart-UPS SC be flashing?
    ... LED lights on Back-UPS Pro, Back-UPS Pro USB, Back-UPS LS, and Smart- UPS SC: causes ... Back-UPS Pro, Back-UPS USB, Back-UPS LS, Back-UPS CS, Back-UPS NS/XS ... , Smart- UPS SC 620va and ... ... indicates that the UPS is performing a ... ... indicates that the UPS has entered " ... " where the UPS will turn off ... The UPS is put into ... included with your Back-UPS Pro after it ...
    What are some issues I may encounter when using an APC Back-UPS with a generator?
    ... for hospitals, are sized large enough and are of good enough quality that any APC UPS will operate fine.
    Video: Back-UPS ES - Procedure for Battery Replacement
    Cause: The internal batteries contained in APC UPS are shipped disconnected per US DOT requirements.
    Video: Connect Battery on Back-UPS RS/NS M2 & MS Series
    All APC UPS systems are shipped with batteries disconnected to comply with US DOT regulations.
    Results 1 - 10 of 50