{}

{"support":{"yesButton":"Да","noButton":"Нет","feedback":{"title":"Что мы можем сделать лучше?"},"submitButton":"Отправить","successMessage":"Благодарим вас за отзыв","title":"Было ли это полезно?","feedbackPercentLabel":"пользователей считают это полезным","captcha":{"error":"Установите флажок"}}}

Поиск часто задаваемых вопросов

{"searchBar":{"inputPlaceholder":"Выполните поиск по ключевому слову или задайте вопрос","searchBtn":"Поиск","error":"Введите ключевое слово для поиска"}}

NetBotz 355 | Physical Description

Issue:
Physical Description of the NetBotz 355 and 355A

Product Line:
NetBotz version 3
- Wall Monitor 355
- Wall Monitor 355A

Environment:
NetBotz 355/355A (all firmware versions)

Resolution:

Physical Description - Front

Item		Description
1	Vented internal sensors	Vented opening for airflow, temperature, and humidity sensors.
2	Network link LED	Shows the status of the network connection. Blinks to indicate network traffic (green = connected at 10 Mbps; yellow = connected at 100 Mbps).
3	Power LED	Indicates whether the unit is receiving power (green = receiving power; dark = not receiving power)
4	Camera LED	Blinks steadily when the integrated camera is active.
5	Alert LED	Indicates the alert status of the system. When more than one alert exists, the most severe will be indicated. - Flashing once every eight seconds = Informational - Flashing one very four seconds = Warning - Flashing once every two seconds = Error - Flashing once every second = Critical - Flashing twice per second = Failure
6	Temperature display	- Displays the current temperature from 0 to 99 in Centigrade or Fahrenheit. The Temperature reading comes from the internal temperature sensor. If the temperature exceeds 99, the display will flash 99. - When the unit first receives power, displays the unique identifier number for one minute. - If an alert exists, flashes at the same rate as the Alert LED. - During firmware upgrade, displays 88.
7	Lens housing	Must be removed to change the focus of the integrated camera.

Physical Description - Back

Item		Description
1	Sensor ports (4)	Used for connecting APC by Schneider Electric sensors, third-party dry-contact sensors, and standard third-party 0-5 V sensors. Third-party dry-contact state sensors require the NetBotz Dry Contact Cable (NBES0304). Standard third-party 0-5 V sensors require the NetBotz 0-5 V Sensor Cable (NBES0305).
2	10/100 Base-T network port	Provides for a 10/100 Base-T network connection and power through Power-over-Ethernet (PoE). (The appliance operates at 100 Base-T only.) Status and link LEDs indicate network traffic: - Status LED: blinks orange and green at start-up, then indicates the status of the network connection (solid green = IP address established; blinking green = attempting to obtain an IP address). - Link LED: blinks to indicate network traffic (green = connected at 10 Mbps; orange = connected at 100 Mbps).
3	USB port	Used to configure the appliance.
4	Reset	Used to restart the appliance.