Browse FAQs
Video: How to take the Galaxy 5000 UPS from total power off to normal operation.
Step 2: Wait until the end of the UPS initialization with PFC start-up . Step 2: Push the Menu Button
Where can I get support for APC and MGE Products?
Assessment Services ... Battery Replacement Services ... Charge- UPS EX ... Installation Services ... Matrix- UPS Matrix- UPS Accessories ... MGE EPS 7000 ... MGE Galaxy MGE Galaxy 300 MGE Galaxy 3000 MGE Galaxy 3500 MGE Galaxy 4000 MGE Galaxy 5000 MGE Galaxy 5500 MGE Galaxy 6000 MGE Galaxy 7000 MGE Galaxy 9000 MGE Galaxy PW ... MGE Service Bypass ... MGE UPS 4000 ... Network Integration Services ... On Site Service ... Project Management Services ... Remote Monitoring Services ... Service Bypass Panel Service Plans ... Smart- UPS Smart- UPS Accessories Smart- UPS Battery Systems Smart- UPS DP Smart- UPS On-Line Smart- UPS RT Smart- UPS VT ... Start-Up Service
APC UPS Network Management Card (NMC) Compatibility Chart
The AP9644 card is backward compatible with any Galaxy VS already installed. When the card is installed after the UPS , however, a new Start-up service (WSTRTUP-VS1-a50) needs to be purchased to upgrade the UPS and the card at the customer site.
Matrix-UPS emits a chirping sound after being on-battery or running a self-test
... pack fails a UPS On-Battery ... scheduled or through UPS start-up ), the Matrix- UPS will emit chirps ... an interval of one minute to warn ...
Video: How to take Galaxy VM UPS out of Maintenance Bypass
... How to take Galaxy VM UPS out of Maintenance ... Galaxy VM ... equipment, the UPS must be transitioned ... maintenance bypass following service or other maintenance ... ... , takes about 1 -2 minutes ... After opening the MBB ( ... top of the UPS and turn the key so the UPS can now go ... This video provides a step by step instruction on how to operate the Galaxy VM UPS from Maintenance Bypass mode to on-line mode, to allow the end-user to transfer load back to the UPS from MBP without interruption: ... Also to transition UPS into Maintenance Bypass
Video: How to Start your Symmetra PX 250/500 UPS
px250-500, Odin, operation, start-up , video
Video: How to take the Galaxy 5000 UPS from normal operation to total power off?
The instructions to power down the UPS are available on the display. This procedure is for a single UPS without an external bypass panel.
How to take the Single Galaxy 5000 UPS from normal operation to total power off using an external Maintenance Bypass Panel
Issue: How to take the Single Galaxy 5000 UPS from normal operation to total power off using an external Maintenance Bypass Panel.
Default password of 1234 does not work on the Display of new Galax VX or Galaxy VM.
... Galax VX or Galaxy VM. Galaxy VX, Galaxy VM ... To conform to California law SB 327 which requires the ender user to change the password when first logging into a network device. The display of the Galaxy VX and VM is part of the NMC and has been disabled. ... Use the console cable supplied with UPS ... Serial port setting: for 9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control. ... Assuming the UPS is connected to the customer network and is granted an DHCP IP address.
How Does Matrix-UPS Report Output Voltage?
... the Matrix- UPS reports its output with respect ... selection (set manually inside the UPS by the user at start-up ).